无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ

无机盐工业 ›› 2025, Vol. 57 ›› Issue (2): 68-75.doi: 10.19964/j.issn.1006-4990.2024-0162

• 研究与开发 • 上一篇    下一篇

钛盐混凝剂深度去除乳化油的性能及机理研究

黄天寅1(), 孙凌1, 赵勤政1, 陈新1, 宋孝杰2, 吴兵党1()   

  1. 1.苏州科技大学环境科学与工程学院,江苏 苏州 215009
    2.中国石化扬子石油化工有限公司,江苏 南京 210048
  • 收稿日期:2024-03-21 出版日期:2025-02-10 发布日期:2025-02-20
  • 通讯作者: 吴兵党(1990— ),男,博士研究生,副教授,主要研究方向为水污染控制技术;E-mail:wubingdang@usts.edu.cn
  • 作者简介:黄天寅(1973— ),男,博士研究生,教授,主要研究方向为水环境修复;E-mail:huangtianyin111@163.com
  • 基金资助:
    姑苏创新创业领军人才项目(ZXL2022500)

Study on performance and mechanism of titanium salt coagulant for treatment of oily wastewater

HUANG Tianyin1(), SUN Ling1, ZHAO Qinzheng1, CHEN Xin1, SONG Xiaojie2, WU Bingdang1()   

  1. 1.School of Environmental Science and Engineering,Suzhou University of Science and Technology,Suzhou 215009,China
    2.SINOPEC Yangzi Petrochemical Co. ,Ltd. ,Nanjing 210048,China
  • Received:2024-03-21 Published:2025-02-10 Online:2025-02-20

摘要:

含油废水中乳化油因其粒径小、稳定性高等特点较难去除,使得废水处理难度加大。混凝法在乳化油处理中应用广泛,但传统的铁、铝盐混凝剂存在产生的絮体小、生成速度慢、难以实现油水快速分离的问题,导致深度除油效果不佳。新型钛盐混凝剂因混凝性能突出有望解决铁铝盐混凝剂应用问题。以润滑油、大豆油、石油醚和柴油4种模拟乳化油水为处理对象,选用聚合硫酸铁(PFS)和聚氯化铝(PAC)为对照,评价钛凝胶混凝剂(TXC)处理含油废水的可行性。结果表明,TXC对乳化油废水具有优于PFS和PAC的混凝效果。以润滑油模拟废水为例,在初始pH范围为3~11、投加量为1~60 mg/L和含油量为500~2 000 mg/L条件下,TXC的除油率最高可达91.526%,优于PFS和PAC。经TXC混凝后出水浊度均小于1 NTU,且油的粒径最小,表明TXC具有深度除油的应用潜力。絮体表征结果表明,TXC主要通过网捕卷扫作用除油,得益于其大尺寸的网状水解物,TXC絮体更易于去除小粒径油滴。该研究结果为含油特别是乳化油废水的处理提供新的思路。

关键词: 乳化油, 混凝, 除油, 粒径, 钛混凝剂

Abstract:

Emulsified oil is more difficult to be removed because of its small particle size and difficult to be agglomerated.Coagulation is widely used in the treatment of emulsified oil.However,the traditional iron and aluminum salt coagulants produce small flocs and have slow generation rate,which make it difficult to realize the rapid separation of oil and water,resulting in poor deep oil removal effect.The new titanium salt coagulant is expected to solve the application problem of iron aluminum salt coagulant due to its outstanding coagulation performance.In this paper,a new type of titanium gel coagulant(TXC) for the treatment of oily wastewater was evaluated by using four kinds of simulated emulsified oil water,such as lubricating oil,soybean oil,petroleum ether and diesel oil,and choosing polyferric sulfate(PFS) and polyaluminum chloride(PAC) as the control.The results showed that TXC had better coagulation effect on emulsified oil wastewater than PFS and PAC.Taking lubricating oil as an example,in the initial pH range of 3~11,dosage of 1~60 mg/L and oil content of 500~2 000 mg/L,the oil removal rate of TXC was up to 91.526%.It was better than PFS and PAC.The turbidity of the oil-bearing wastewater after TXC coagulation was less than 1 NTU,and the particle size of the oil was the smallest,which indicated that TXC had the application potential of deep oil removal.The results of floc characterization showed that TXC mainly removed oil by net sweeping,and because of its large floc size,it was easier to remove small particle size oil droplets.The research results provided new ideas for the treatment of oily wastewater,especially emulsified oil wastewater.

Key words: emulsified oil, coagulation, oil removal, particle size, titanium coagulant

中图分类号: