无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ

无机盐工业 ›› 2016, Vol. 48 ›› Issue (5): 20-.

• 论文 • 上一篇    下一篇

对甲苯磺酸钠诱导直接转化制备氢氧化镁

李三喜,宋书冬,王 松,谢梅竹   

  1. 沈阳工业大学理学院,辽宁沈阳 110870
  • 出版日期:2016-05-10 发布日期:2016-05-16

Direct conversion preparation of magnesium hydroxide induced by sodium p-toluene sulfonate

 LI  San-Xi, SONG  Shu-Dong, WANG   Song, XIE  Mei-Zhu   

  1. School of Science,Shenyang University of Technology,Shenyang 110870,China
  • Published:2016-05-10 Online:2016-05-16

摘要: 为了省去酸解步骤,以水镁石为原料制备晶型良好、表面极性较低的氢氧化镁,采用对甲苯磺酸钠作为诱导剂,诱导活化后的水镁石直接转化水热制备氢氧化镁。对水热时间、温度、氢氧化钠溶液浓度做了单因素实验。实验得到最佳反应条件:对甲苯磺酸钠与水镁石粉物质的量比为1∶20、填充度为70%、水热时间为12 h、水热温度为200 ℃、氢氧化钠溶液浓度为5 mol/L。通过谢乐公式计算出所得纳米氢氧化镁的平均晶粒尺寸为14.6 nm。

关键词: 水镁石, 对甲苯磺酸钠, 诱导剂, 水热

Abstract: In order to save acid solution step,well crystalline and lower surface polarity magnesium hydroxide was prepared.The magnesium hydroxide was obtained with direct conversion hydrothermal,and through taking activated brucite as raw material and induced by sodium p-toluene sulfonate.The optimum reaction conditions were selected by the single factor test of the hydrothermal time,temperature,and NaOH concentration.The optimum reaction conditions were determined as follows: amount-of-substance ratio of sodium p-toluene sulfonate to brucite was 1∶20,filling degree was 70%,hydrothermal time was 12 h,hydrothermal temperature was 200 ℃,and concentration of NaOH solution was 5 mol/L.And the average grain size of nano-sized magnesium hydroxide was calculated as 14.6 nm by Scherrer formula.

Key words: brucite, sodium p-toluene sulfonate, inducer, hydrothermal

中图分类号: