无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ

无机盐工业 ›› 2013, Vol. 45 ›› Issue (7): 31-.

• 论文 • 上一篇    下一篇

DTAB表面活性剂在硅气凝胶干燥中的应用

王雪枫,吴林后,田 玲,黄雪莉,赵建茹   

  1. 石油天然气精细化工教育部和自治区重点实验室,新疆大学化学化工学院,新疆乌鲁木齐 830046
  • 出版日期:2013-07-10 发布日期:2013-07-16

Application of DTAB surfactant in drying of silica aerogel

 WANG  Xue-Feng, WU  Lin-Hou, TIAN   Ling, HUANG  Xue-Li, ZHAO  Jian-Ru   

  1. Key Laboratory of Oil and Gas Fine Chemicals,Ministry of Education and Xinjiang Uyghur Autonomous Region,
    School of Chemistry and Chemical Engineering,Xinjiang University,Urumqi 830046,China
  • Online:2013-07-10 Published:2013-07-16

摘要: 使用十二烷基三甲基溴化铵(DTAB)阳离子表面活性剂溶液对湿凝胶进行处理,可降低凝胶中液体表面张力,从而得到保持较完整孔隙结构的硅气凝胶。结果表明,采用DTAB水溶液浸泡湿凝胶的方法要优于在凝胶形成前加入DTAB的方式。使用浓度为1.48×10-2 mol/L的DTAB水溶液浸泡湿凝胶可得到孔隙率为81.8%、平均孔径为15.749 nm、总孔体积为2.836 cm3/g、比表面积为923 m2/g的二氧化硅气凝胶;其吸脱附曲线明显高于其他添加浓度的吸脱附曲线,表明具有较高的吸附能力;在TEM图中可明显看出其具有孔隙结构。DTAB处理过的气凝胶明显优于未经处理的二氧化硅气凝胶。

关键词: 表面活性剂, 硅气凝胶, 十二烷基三甲基溴化铵

Abstract: The wet gel has been treated by cationic surfactant of dodecyltrimethylammonium bromide(DTAB) aqueous solution,so that the liquid surface tension can be reduced in the wet gel and the silica aerogel with intact pore structure can be obtained.Results showed that the method of using DTAB solution to soak wet gel is better than the method of adding DTAB before the forming of wet gel.The test parameters of silica aerogel were as follows: porosity of 81.8%,average pore size of 15.749 nm,total pore volume of 2.836 cm3/g,and specific surface area of 923 m2/g,when the wet gel was soaked in 1.48× 10-2 mol/L DTAB aqueous solution;the adsorption and desorption curve was obviously higher than that of other concentrations of DTAB,exhibiting strong adsorptivity;the pore structure can be observed clearly from the TEM photogaphy;and the silica aerogel after being treated by DTAB was significantly better than those without treatment.

Key words: surfactant, silica aerogel, dodecyltrimethylammonium bromide

中图分类号: