无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ

无机盐工业 ›› 2021, Vol. 53 ›› Issue (3): 34-37.doi: 10.11962/1006-4990.2020-0208

• 研究与开发 • 上一篇    下一篇

橄榄石酸溶制备超细二氧化硅改性研究

王玲1(),熊雨婷1,崔兆纯1,贾蓝波1,范晨子2,刘淑贤1,聂轶苗1   

  1. 1.华北理工大学矿业工程学院,河北省矿业开发与安全技术重点实验室,河北唐山 063210
    2.国家地质实验测试中心
  • 收稿日期:2020-09-20 出版日期:2021-03-10 发布日期:2021-03-11
  • 作者简介:王玲(1977— ),女,博士,副教授,主要研究方向为材料及环境矿物学;E-mail:wanglingts_@163.com
  • 基金资助:
    河北省高等学校科学研究计划项目(QN2015091);唐山市科技局项目(19130216g);唐山市工业固体废弃物清洁利用基础创新团队项目(19130207C);中国地质调查项目(DD20190589)

Modification of ultrafine silica prepared by olivine acid dissolution

Wang Ling1(),Xiong Yuting1,Cui Zhaochun1,Jia Lanbo1,Fan Chenzi2,Liu Shuxian1,Nie Yimiao1   

  1. 1. Hebei Province Key Laboratory of Mining Exploitation and Security Technology,College of Mining Engineering,North China University of Science and Technology,Tangshan 063210,China
    2. National Research Center for Geoanalysis
  • Received:2020-09-20 Online:2021-03-10 Published:2021-03-11

摘要:

橄榄石酸溶制备超细二氧化硅工艺简单、生产成本低。但是制备的超细二氧化硅表面羟基键合严重、分散性能差、易团聚。利用硅烷偶联剂对橄榄石酸溶制备的超细二氧化硅进行改性研究。采用单因素实验考察了硅烷偶联剂品种、改性时间、改性温度及改性剂用量等因素对超细二氧化硅改性效果的影响。实验结果表明,在硅烷偶联剂KH-550加入量为6 mL/g、改性时间为5 h、改性温度为75 ℃条件下,制备的超细二氧化硅表面的羟基数量减少至2.08×10 20 个/g、接枝率为8.35%、接触角达到101.51°,极大地提高了超细二氧化硅的表面疏水性。

关键词: 超细二氧化硅, 橄榄石酸溶, 硅烷偶联剂, 表面改性

Abstract:

Preparation of ultrafine silica by olivine acid dissolution is simple and low-cost,however,the ultrafine silica are liable to agglomerate with poor dispersing property due to strong hydrophilicity.Silane coupling agent was used to modify the ultrafine silica prepared by olivine acid dissolution.The effects of varieties and dosage of modifier,modifying time and temperature on the modification of silica were investigated by single factor method.The results show that the number of hydroxyl on the surface of ultrafine silica can be reduced to 2.08×10 20 units/g,the grafting rate is 8.35% and the contact angle is 101.51° when the addition of silane coupling agent KH-550 is 6 mL/g,modifying time is 5 h and reaction temperature is 75 ℃,which improves the hydrophobicity of ultrafine silica greatly.

Key words: ultrafine silica, acid dissolution of olivine, silane coupling agent, surface modification

中图分类号: