无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ

无机盐工业 ›› 2024, Vol. 56 ›› Issue (6): 139-146.doi: 10.19964/j.issn.1006-4990.2023-0428

• 催化材料 • 上一篇    下一篇

工艺条件对柴油吸附分离重芳烃轻质化反应的影响

刘凯隆1(), 朱孔义3, 郭春垒1, 马晓彪1, 王宇健1, 盛强2, 李翔2, 王银斌1, 靳凤英1   

  1. 1.中海油天津化工研究设计院有限公司,天津 300131
    2.天津科技大学化工与材料学院,天津 300457
    3.内蒙古伊泰石油化工有限公司,内蒙古 鄂尔多斯 017000
  • 收稿日期:2023-08-29 出版日期:2024-06-10 发布日期:2024-06-20
  • 作者简介:刘凯隆(1994— ),男,硕士,工程师,从事芳烃化工材料及催化剂优化;E-mail:liukailong09@163.com
  • 基金资助:
    国家重点研究计划项目(E-J723TH05);中海油能源发展重大科技专项课题(HFZXKT-TJY2020-01)

Effects of process condition on performance of diesel aromatic to light aromatic

LIU Kailong1(), ZHU Kongyi3, GUO Chunlei1, MA Xiaobiao1, WANG Yujian1, SHENG Qiang2, LI Xiang2, WANG Yinbin1, JIN Fengying1   

  1. 1.CenerTech Tianjin Chemical Research and Design Institute Co. ,Ltd. ,Tianjin 300131,China
    2.College of Chemical Engineering and Materials Science,Tianjin University of Science and Technology,Tianjin 300457,China
    3.Inner Mongolia YiTai Petrochemical Institute Limited Co. ,Ltd. ,Ordos 017000,China
  • Received:2023-08-29 Published:2024-06-10 Online:2024-06-20

摘要:

馏分油芳烃吸附分离技术是炼厂过剩汽、煤、柴油资源高效利用的途径。分离得到的非芳烃组分可通过蒸汽裂解或催化裂解增产低碳烯烃,以单环芳烃为主的芳烃组分则可通过重芳烃轻质化技术增产苯、甲苯和二甲苯等轻质芳烃,同时副产优质乙烯裂解原料。以吸附分离重芳烃组分为原料,测定了氢气溶解量。吸附分离重芳烃油中氢气的溶解量随温度和氢压的增加而增加,达到1.0×10-4~3.2×10-4 mol/g,比油中多环芳烃加氢成单环芳烃所需理论耗氢量低1~2个数量级。进一步采用NiMo/β轻质化催化剂在固定床反应器上考察了催化剂还原条件、反应器高径比、反应温度、氢分压、氢油比、空速等工艺参数对吸附分离重芳烃轻质化反应的影响。在低温高压(350 ℃、4 MPa)的还原工况下,反应器高径比为4.5、反应温度为400~410 ℃、氢分压为5.0~5.5 MPa、氢油体积比为800~1 000、质量空速为1~1.5 h-1的条件下,吸附分离重芳烃轻质化效果最佳,C10+转化率≥85%,C6~C9芳烃收率≥50%,C6~C9芳烃纯度≥97.5%。柴油芳烃吸附分离和重芳烃轻质化可实现高效耦合,显著提高化工品收率,具有重大的现实意义和广阔的应用前景。

关键词: 吸附分离芳烃, 柴油芳烃, 重芳烃轻质化, 芳烃收率, 溶氢

Abstract:

The adsorptive separation of heavy aromatics from fuel fractions yields is an efficient way to utilize surplus gasoline and diesel resources in refineries.The non-aromatic products can be used to increase the production of low-carbon olefins through steam cracking or catalytic cracking processes.The aromatic products are mainly composed of mono-aromatics,which can be turned into good feedstocks for ethylene production and light aromatics like benzene,toluene,and xylene through the heavy aromatic lightening technology.The hydrogen solubility was measured using adsorption separation of heavy aromatic hydrocarbon components as raw materials.The solubility of H2 in the heavy aromatics was between 1.0×10-4~3.2×10-4 mol/g,and increased with temperature and H2 pressure.It was 1~2 order of magnitude lower than that needed for the hydrogenation of ploy-aromatics to mono-aromatics.The effects of the reduction temperature of catalyst precursor,the aspect ratio of fixed-bed reactor,the reaction temperature,the H2 partial pressure,the H2-oil ratio,and the weight hourly space velocity(WHSV) on the lightening of heavy aromatics obtained by adsorptive separation from a diesel fractions over a NiMo/β catalyst were also studied.Over the catalyst prepared by reduction of the precursor under relatively low temperature and high pressure(350 ℃ and 4 MPa),the optimal reaction conditions were aspect ratio of 4.5,reaction temperature of 400~410 ℃,H2 pressure of 5.0~5.5 MPa,H2-oil ratio of 800~1000,and WHSV of 1~1.5 h-1.Under the conditions,the conversion of the C10+ compounds was above 85%,while the yield and the purity of C6~C9 aromatics were more than 50% and 97.5%,respectively.The coupling of diesel adsorptive separation and the lightening of the obtained heavy aromatics to light aromatics greatly improved the yields of chemicals from diesel fractions,which made broad application prospect and enormous practical significance.

Key words: adsorption separation process of aromatics, diesel aromatic, heavy aromatics to light aromatic, aromatic yield, H2 solubility

中图分类号: