煅烧法与常压酸化法制备磷Ⅱ型无水石膏的水化性能研究
收稿日期: 2023-05-10
网络出版日期: 2024-02-06
基金资助
国家重点研发计划项目(2018YFC1900206-2);贵州省科技计划项目(黔科合平台人才［2019］5409号);校企合作项目(YTH4420-WB-FW-2022-001009-00)
Study on hydration properties of type Ⅱ anhydrite prepared by calcination and atmospheric acidification
Received date: 2023-05-10
Online published: 2024-02-06
以磷石膏为原料，分别采用煅烧法和常压酸化法制备磷Ⅱ型无水石膏，通过物相组成、微观形貌、化学组成及粒径分布，分析比较了两种方法制备的磷Ⅱ型无水石膏的差异性。在激发剂明矾不同掺量下，分析比较不同制备方法对磷Ⅱ型无水石膏的凝结时间、硬化体强度及水化率的影响。结果表明：由煅烧法制得的磷Ⅱ型无水石膏AH-1的微观形貌呈菱形，由常压酸化法制得的磷Ⅱ型无水石膏AH-2的微观形貌呈矩形，其中AH-2结晶度及纯度高、平均粒径小、比表面积大；当未掺明矾时，无水石膏水化硬化缓慢，终凝时间在35 h以上，28 d水化率在30%左右；当明矾质量分数为1%时，AH-1的终凝时间由40 h 20 min缩短至5 h 40 min，AH-2的终凝时间由35 h 20 min缩短至4 h 20 min，28 d抗压强度分别为空白组的2.54倍和3.01倍；随着明矾掺量的增加，AH-1和AH-2的性能差异逐渐减小，AH-1和AH-2的终凝时间相差在30 min以内，28 d抗压强度均为空白组的3.2倍。同时，AH-2水化生成的二水石膏表面光滑，搭接更加致密。通过比较可知，常压酸化法制备磷Ⅱ型无水石膏工艺更具优势。
张桂东 , 杨雪娇 , 郭旭东 , 杨林 . 煅烧法与常压酸化法制备磷Ⅱ型无水石膏的水化性能研究[J]. 无机盐工业, 2024 , 56(2) : 104 -110 . DOI: 10.19964/j.issn.1006-4990.2023-0264
Type Ⅱ anhydrite was prepared by calcination method and atmospheric acidification method using phosphogypsum as raw material.The differences of type Ⅱ anhydrite prepared by the two methods were analyzed and compared through the analysis of phase composition，micro-morphology，chemical composition and particle size distribution.The effects of different preparation methods on the setting time，hardening strength and hydration rate of type Ⅱ anhydrite were analyzed and compared under different dosage of alum.The results showed that the microstructure of type Ⅱ anhydrite AH-1 prepared by calcination was diamond shaped，and that of type Ⅱ anhydrite AH-2 prepared by atmospheric acidification was rectangular，in which AH-2 had high crystallinity and purity，small average particle size and large specific surface area.When the anhydrite was not mixed with alum，the hydration hardening was slow，the final coagulation time was more than 35 h，and the hydration rate was about 30% in 28 d.When the alum content was 1%（mass fraction），the final coagulation time of AH-1 was shortened from 40 h 20 min to 5 h 40 min，the final coagulation time of AH-2 was shortened from 35 h 20 min to 4 h 20 min，and the compressive strength of 28 d was 2.54 times and 3.01 times of that of the blank group，respectively.With the increase of alum content，the performance difference between AH-1 and AH-2 was gradually decreased.The final coagulation time difference between AH-1 and AH-2 was less than 30 min，and the 28 d compressive strength was 3.2 times that of the blank group.At the same time，the surface of the dihydrate gypsum produced by AH-2 hydration was smooth and the bonding was more dense.By comparison，it could be seen that the preparation process of type Ⅱ anhydrite by atmospheric pressure acidification was more advantageous.
Key words： phosphogypsum; type Ⅱ anhydrite; activation; hydration hardening
| 1 | 崔荣政，白海丹，高永峰，等.磷石膏综合利用现状及“十四五”发展趋势［J］.无机盐工业，2022，54（4）：1-4. |
| CUI Rongzheng， BAI Haidan， GAO Yongfeng，et al.Current situation of comprehensive utilization of phosphogypsum and its development trend of 14th Five-Year Plan［J］.Inorganic Chemicals Industry，2022，54（4）：1-4. | |
| 2 | ZHANG Wenyan， ZHAO Liya， XUE Mengfen，et al.Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum［J］.Journal of Cleaner Production，2023，396：136455. |
| 3 | 黎明川，韦家崭，陈平，等.转晶剂与蒸压参数对磷石膏制备α半水石膏的影响［J］.无机盐工业，2022，54（8）：132-137. |
| LI Mingchuan， WEI Jiazhan， CHEN Ping，et al.Effect of crystal modifier and autoclave parameters on preparation of α-hemihydrate gypsum from phosphogypsum［J］.Inorganic Chemicals Industry，2022，54（8）：132-137. | |
| 4 | CAO Wenxiang， YI Wei， PENG Jiahui，et al.Preparation of anhydrite from phosphogypsum：Influence of phosphorus and fluorine impurities on the performances［J］.Construction and Building Materials，2022，318：126021. |
| 5 | 朱鹏程，彭操，张应虎.磷石膏制备高品质Ⅱ型无水石膏试验研究［J］.化工矿物与加工，2018，47（7）：19-22. |
| ZHU Pengcheng， PENG Cao， ZHANG Yinghu.Experimental study on preparation of high quality type Ⅱ anhydrous gypsum with pho-sphogypsum［J］.Industrial Minerals & Processing，2018，47（7）：19-22. | |
| 6 | 马小玲，谭宏斌，杨飞华.常压酸水体系制备无水硫酸钙晶须及形貌调控［J］.非金属矿，2021，44（1）：81-83. |
| MA Xiaoling， TAN Hongbin， YANG Feihua.Preparation and morphology control of anhydrous calcium sulfate whiskers in acid water system under autoclave-free［J］.Non-Metallic Mines，2021，44（1）：81-83. | |
| 7 | 张建新.天然硬石膏水化硬化及活性激发研究［D］.重庆：重庆大学，2009. |
| ZHANG Jianxin.Study on hydration and hardening of natural anhydrite and its activation［D］.Chongqing：Chongqing University，2009. | |
| 8 | 张宇，杨家豪，刘瑜，等.Ⅱ型无水磷石膏凝结硬化过程调控技术［J］.化工进展，2022，41（10）：5637-5644. |
| ZHANG Yu， YANG Jiahao， LIU Yu，et al.Regulating technology of setting and hardening process of anhydrite-Ⅱ phosphogyps-um［J］.Chemical Industry and Engineering Progress，2022，41（10）：5637-5644. | |
| 9 | 毕强，梅毅，夏举佩.磷Ⅱ型无水石膏制备及活性联合激发基础研究［J］.化工进展，2023，42（10）：5427-5435. |
| BI Qiang， MEI Yi， XIA Jupei.Basic research on preparation and activity combined excitation of anhydrite-Ⅱ phosphogypsum［J］.Chemical Industry and Engineering Progress，2023，42（10）：5427-5435. | |
| 10 | 许林青，周富涛，石宗利.利用磷石膏制备硬石膏水泥的研究［J］.硅酸盐通报，2010，29（1）：102-106. |
| XU Linqing， ZHOU Futao， SHI Zongli.Study on manufacture of anhydrite from phosphogypsum［J］.Bulletin of the Chinese Ceramic Society，2010，29（1）：102-106. | |
| 11 | CHEN Shun， XIONG Guoqing， SU Ying，et al.Laboratory evaluation for utilization of phosphogypsum through carbide slag highly-effective activating anhydrous phosphogypsum［J］.Journal of Wuhan University of Technology-Materials Science Edition，2021，36（3）：392-399. |
| 12 | 李德星，郭荣鑫，林志伟，等.磷石膏制备α半水石膏的研究现状［J］.硅酸盐通报，2022，41（3）：860-869. |
| LI Dexing， GUO Rongxin， LIN Zhiwei，et al.Research status of preparation of α-hemihydrate gypsum from phosphogypsum［J］.Bulletin of the Chinese Ceramic Society，2022，41（3）：860-869. | |
| 13 | 彭芃.天然硬石膏活性激发及膨胀特性研究［D］.重庆：重庆大学，2021. |
| PENG Peng.Study on activation and expansion characteristics of natural anhydrite［D］.Chongqing：Chongqing University，2021. | |
| 14 | 杨敏，曹建新，谢燕.半水石膏激发Ⅱ型无水磷石膏的研究［J］.武汉理工大学学报，2010，32（18）：63-65. |
| YANG Min， CAO Jianxin， XIE Yan.Activation of anhydrite-Ⅱ phosphogypsum by hemihydrate［J］.Journal of Wuhan University of Technology，2010，32（18）：63-65. |
/
| 〈 |
|
〉 |
