无机盐工业
主管:中海油天津化工研究设计院有限公司
主办:中海油天津化工研究设计院有限公司
   中海油炼油化工科学研究院(北京)有限公司
   中国化工学会无机酸碱盐专业委员会
ISSN 1006-4990 CN 12-1069/TQ
无机盐工业

器外预硫化型加氢催化剂的制备与性能研究

  • 彭雪峰 ,
  • 于海斌 ,
  • 宋国良 ,
  • 张玉婷 ,
  • 张尚强 ,
  • 张景成 ,
  • 孙彦民 ,
  • 辛 峰
展开
  • 1.天津大学化工学院,天津 300072;2.中海油天津化工研究设计院有限公司,天津市炼化催化技术工程中心
彭雪峰(1985— ),男,博士,高级工程师,主要研究方向为硫化型加氢催化剂高效制备与再生预硫化成套技术的开发与工业应用,曾获《无机盐工业》杂志第一届天化杯优秀论文二等奖、天津市企业博士后创新项目择优资助计划特别资助、天津市化工学会科技软课题研究成果二等奖、中海油能源发展股份有限公司优秀专利成果奖、中海油能源发展股份有限公司科技成果二等奖和中国海洋石油集团有限公司科技进步三等奖等,已发表研究论文10余篇,申请国家发明专利20余项;E-mail:jxfengye@163.com。 通讯作者:辛峰;E-mail:xinf@tju.edu.cn。于海斌;E-mail:yuhaibin9227@163.com。

网络出版日期: 2020-02-28

Preparation and properties of ex?鄄situ presulfurization hydrogenation catalyst

  • Peng Xuefeng ,
  • Yu Haibin ,
  • Song Guoliang ,
  • Zhang Yuting ,
  • Zhang Shangqiang ,
  • Zhang Jingcheng ,
  • Sun Yanmin ,
  • Xin Feng
Expand
  • 1.School of Chemical Engineering and Technology,Tianjin University,Tianjin 300072,China; 2.Tianjin Refining Catalytic Technology Engineering Center,CNOOC Tianjin Chemical Research and Design Institute Co.,Ltd.

Online published: 2020-02-28

摘要

以Ni和Mo为活性组分,Al2O3为载体,制备了氧化型Ni-Mo/Al2O3催化剂O-1,在此基础上,以自制的水溶性复合硫化物为硫化剂,制备了器外预硫化型Ni-Mo/Al2O3催化剂S-1,通过BET、XRD和HRTEM等手段对2种催化剂的物化性质做了表征,并对比考察了催化剂对劣质石脑油加氢脱硫脱氮的性能。结果表明:器外预硫化型催化剂对劣质石脑油加氢脱硫脱氮的性能与氧化型催化剂接近,其加氢石脑油产品的硫氮含量均低于0.5 μg/g,这说明采用水溶性复合硫化物为硫化剂可以对氧化型催化剂进行有效地器外预硫化。

本文引用格式

彭雪峰 , 于海斌 , 宋国良 , 张玉婷 , 张尚强 , 张景成 , 孙彦民 , 辛 峰 . 器外预硫化型加氢催化剂的制备与性能研究[J]. 无机盐工业, 2019 , 51(11) : 78 -81 . DOI: 10.11962/1006-4990.2018-0680

Abstract

The oxidized Ni-Mo/Al2O3 catalyst O-1 was prepared by using Ni and Mo as active components and Al2O3 as support.On this basis,a self made water soluble composite sulfide was used as vulcanizing agent to prepare the exsitu presulfurization Ni-Mo/Al2O3 catalyst S-1.The physicochemical properties of the two catalysts were characterized by BET,XRD and HRTEM.The performance of the catalyst for hydrodesulfurization and hydrodenitrogenation of inferior naphtha was investigated.Results showed that the performance of the exsitu presulfurization catalyst on the hydrodesulfurization and hydrodenitrogenation of inferior naphtha was close to that of the oxidized catalyst,and the sulfur and nitrogen contents of hydrogenated naphtha products were less than 0.5 μg/g.The oxidized catalyst can be effectively prevulcanized by using a water soluble composite sulfide as a vulcanizing agent.
Options
文章导航

/